Farralane.com - Shure KSM32 Embossed Single-Diaphragm Microphone

An embossed single-diaphragm, side-address, cardioid condenser microphone for highly critical studio recording and live sound productions. The Shure KSM32 offers an extended frequency response for an open, natural sounding reproduction of the original sound source.

Class A, transformerless preamplifier circuitry eliminates cross-over distortion for improved linearity across the full frequency range.
Embossed, high-compliance diaphragm provides extended low-frequency response.
Ultra-thin, gold-layered, low-mass, Mylar® diaphragm for excellent transient response
15 dB attenuation switch for handling extremely high sound pressure levels (SPL)
Switchable low-frequency filter provides greater flexibility to reduce background noise or to counteract proximity effect.
Integrated three-stage pop protection grille reduces "pop" and other breath noise
Internal shock mount reduces transmission of handling noise
Replacement cartridge: RK374

Performance Characteristics

Extended frequency response
Very low self-noise
Exceptional low-frequency reproduction
High output level
High input SPL capability
No cross-over distortion

Cartridge Type: Permanently-biased Condenser
Frequency Response: 20 to 20,000 Hz; View Larger
Directional Polar Pattern: Cardioid
Output Impedance: 150 ohms (actual)
Attenuation Switch: 0 or -15 dB attenuation
Low Frequency response switch: flat -6 db/octave below 115 Hz; -18 dB/octave below 80 Hz
Phantom Power: 48 Vdc +/- 4 Vdc (IEC-268-15/DIN 45 596), positive pins 2 and 3
Current Drain: 4.65 mA typical at 48 Vdc
Common Mode Rejection: > 50 dB, 20 Hz to 20 kHz
Polarity: Positive pressure on diaphragm produces positive voltage on output pin 2 relative to pin 3
Dimensions and Weight: 55.9 mm (2.20 in.) maximum body diameter, 187 mm (7.37 in.) long; 490 grams (17.3 oz.)

Sensitivity (typical, at 1000 Hz; 1 Pa = 94 dB SPL): -36 dBV/Pa (16 mV)
Self-noise (typical, equivalent SPL; A-weighted, IEC 651): 13 dB
Maximum SPL at 1000 Hz: 139 (154) dB; 133 (148) dB
Output Clipping Level*: 2500 ohm load (Attenuator on): 9 dBV; 1000 ohm load (Attenuator on): 3 dBV; *20 Hz to 20 kHz; THD < 1%. THD of microphone preamplifier when applied input signal is equivalent to cartridge output at specified SPL
Dynamic Range: 2500 ohm load: 126 dB; 1000 ohm load: 119 dB
Signal to Noise ratio**: 81 dB; **S/N ratio is difference between 94 dB SPL and equivalent SPL of self-noise, A-weighted
Total Harmonic Distortion (THD), 2500 ohm load: <0.08% for a 120 dB equivalent SPL input