ART Pro Audio USB Phono Plus - Phono Preamplifier and Audio Interface

The USB Phono Plus Project Series is a top-tier USB audio interface featuring a built-in phono preamp. Bridging your computer and an array of analog and digital sources, it offers switchable inputs between Phono and Line levels, complemented by a Low Cut filter to eliminate rumble and wind noise while preserving audio integrity. With a front Gain Trim control and Signal/Clip LED, you can fine-tune the analog to digital converter for various input sources.

For monitoring, the front panel USB Monitor/headphone jack and rear Optical Output allow you to monitor computer audio output. The USB Monitor/headphone jack enables zero-latency monitoring of input sources, facilitating easy cueing of records and tapes. The integrated low-noise Phono Preamp adheres precisely to the RIAA standard, while Line Out jacks are connected to the input preamp signal for source monitoring or standalone phono preamp use.

Encased in a robust all-aluminum black anodized case, the USB Phono Plus Project Series can be powered via external source or directly from the USB port, facilitating hassle-free remote recording. Optical TOSLINK Input and Output, along with an S/PDIF Input, enable utilization as a digital audio to USB interface.

Fully compliant with USB 2.0 specifications, the USB Phono Plus Project Series utilizes USB adaptive mode for playback and USB asynchronous mode for recording. It employs the standard "USB Audio CODEC" driver built into most modern operating systems, simplifying setup without requiring special drivers. The included CDROM contains the user manual and Audacity recording software to kickstart your recording journey.

Features

• Housed in an all aluminum black anodized case
• Powered by external power supply or directly via USB port
• Fully compliant with the USB 2.0 specification and uses USB adaptive mode for playback and USB asynchronous mode for record.
• Works with Windows 98SE/ME/2000/XP/Vista/7 USB audio device drivers as well as Apple OS9.1/OS-X computers with native USB support.
• USB Phono Plus ships with Audacity

Specifications

• Frequency Response: 10 Hz - 50 kHz, +/- 0.5%
• THD: <0.01% typical @ 1 kHz
• Hum and Noise: >90 dB below clipping
• Input Impedance: 47k Ohms/100pf (phono), 270k Ohms (line)
• Maximum Input Level: 40 mV rms @ 1 kHz (phono), +19dBu (line)
• Maximum Gain: 45dB @ 1 kHz (phono), 6dB (line)
• Analog Input Connections: RCA (preamp / phono/line output)
• Analog Output Connection: RCA (preamp line output), 1/8-inch (monitor/headphone output)
• Maximum Output Level: +6dBu (1.4V rms)
• Filter Type / Response: Switchable, high pass (low cut) -3dB @ 22 Hz
• A/D-D/A: 16 bit, 44.1 kHz or 48 kHz, USB selectable from computer, 0.4 ms A/D latency @ 44.1 kHz
• Digital Audio Interface: TOSLINK Opto In to USB, TOSLINK Opto Out from USB, S/PDIF coax (RCA) In to USB
• Computer Interface: USB Class compliant plug-and-play Mac and PC interface
• Chassis Type: All aluminum black anodized with integral rubber sides
• Power Requirements: USB bus powered or 7-12V DC or 9-12V AC @ 150mA (external). Either polarity of the tip will work with DC power
• Dimensions(HWD): 1.85-inch x 4.6-inch x 4.5-inch
• Weight: 1.35 lbs, 0.61 kg